HessAmerica Specsheets

C A S S I N O 9 0 0 Illuminating Bollard	Project Name
	Address
	City
	State
	ZIP

Dimensions (right click to enlarge and/or print)

Type	Model	Watt	Lamp	Volt	Mounting	Finish	Option
	CS900	13 18	CF - Compact Fluorescent	2 - 120 7 - 277	D - Bollard	SG - Silver Grey CC - Custom Color	N - None

Ordering Information

Comment
Specifications are subject to change without notification

HessAmerica . P.O. Box 28 . Gaffney,SC 29342 . Phone: 864-487-3535 . Fax: 864-487-3175 . www.hessamerica.com

Specifications

DESCRIPTION

Illuminating bollard for low-level pathway illumination where contemporary styling is desired.

HOUSING

Single 6060 aluminum alloy rear sidewall and front ledge mount to the square cast aluminum base with concealed hardware. Sidewall and ledge are 0.60” thick. Sidewall has two ribs attached to the inner side to provide positive alignment of the lens. Matte acrylic cubic lens with integral flange has single white acrylic panel bonded to the outer surface to align the lens assembly to the luminaire sidewall. Two cast aluminum fascia elements seal the lens assembly to the single piece EPDM gasket on the base and are secured with countersunk stainless steel screws. Luminaire mounts to 0.197” thick wall extruded aluminum shaft with two concealed socket head cap screws. All hardware is stainless steel.

OPTICS

Base down lamp is positioned within the matte acrylic cubic lens providing soft diffused illumination.

ELECTRICAL

Compact fluorescent high frequency electronic ballast shall be Class P and Outdoor Type 1 rated. Ballast shall have a minimum high power factor rating of 90% and a minimum starting temperature of -20°F (-30°C) at nominal line voltage ±10%. Ballast shall be UL Listed. Lamp sockets are 75w-600v rated.

LAMPING

Wattage
Source
Lamp
Bulb
Base

13
Compact Fluorescent
CFQ13W/G24q
PL-C
G24q-1

18
Compact Fluorescent
CFTR18W/GX24q
PL-T
GX24q-2

Lamp is included.

MOUNTING

Bollard mounts to anchor base plate assembly with four M10 x 20mm stainless steel socket head cap screws and washers. Anchor base assembly consists of four ½” x 17” x 3” hot-dip galvanized anchor rods secured to a mounting plate and embedded as an assembly in concrete foundation (by others).

FINISH

Housing is cleaned ultrasonically prior to painting. Standard finish is finely textured matte silver grey metallic. Special colors available on request.

WARRANTY

Limited product warranty period is three years. Lamp and ballast shall carry the respective manufacturer's limited warranty.

CERTIFICATION

Listed for Wet Locations.

Specifications are subject to change without notification